de0f5c9d1e
Fix value passed to SPEED The SPEED parameter of SET_FAN_SPEED needs to be between 0.0 and 1.0. Since the S param, which is between 0 and 255, was being passed as is to SPEED, it effectively resulted in the target fan running at 100% if any value > 0 was passed to M106.
1 KiB
1 KiB
OrcaSlicer use M106 P3 command to control air-filtration/exhuast fan.
If you are using Klipper, you can define a M106 macro to control the both normal part cooling fan and auxiliary fan and exhuast fan.
Below is a reference configuration for Klipper.
Note: Don't forget to change the pin name to the actual pin name you are using in the configuration
# instead of using [fan], we define the default part cooling fan with [fan_generic] here
# this is the default part cooling fan
[fan_generic fan0]
pin: PA7
cycle_time: 0.01
hardware_pwm: false
# this is the auxiliary fan
# comment out it if you don't have auxiliary fan
[fan_generic fan2]
pin: PA8
cycle_time: 0.01
hardware_pwm: false
# this is the exhaust fan
# comment out it if you don't have exhaust fan
[fan_generic fan3]
pin: PA9
cycle_time: 0.01
hardware_pwm: false
[gcode_macro M106]
gcode:
{% set fan = 'fan' + (params.P|int if params.P is defined else 0)|string %}
{% set speed = (params.S|float / 255 if params.S is defined else 1.0) %}
SET_FAN_SPEED FAN={fan} SPEED={speed}