{
	"type": "machine",
	"setting_id": "GM001",
	"name": "Elegoo Neptune 4 (0.6 nozzle)",
	"from": "system",
	"instantiation": "true",
	"inherits": "fdm_neptune_4_common",
	"printer_model": "Elegoo Neptune 4",
	"default_print_profile": "0.20mm Standard @Elegoo Neptune4 (0.6 nozzle)",
	"gcode_flavor": "klipper",
	"nozzle_diameter": [
		"0.6"
	],
	"printer_variant": "0.6",
	"printable_area": [
		"0x0",
		"225x0",
		"225x225",
		"0x225"
	],
	"printable_height": "265",
	"nozzle_type": "hardened_steel",
	"auxiliary_fan": "0",

	"max_layer_height": [
		"0.4"
	],
	"min_layer_height": [
		"0.08"
	],
	"printer_settings_id": "Elegoo",
	"retraction_minimum_travel": [
		"1"
	],
	"retract_before_wipe": [
		"85%"
	],
	"retraction_length": [
		"5"
	],
	"retract_length_toolchange": [
		"2"
	],
	"deretraction_speed": [
		"45"
	],
	"single_extruder_multi_material": "1",
	"change_filament_gcode": "M600",
	"machine_pause_gcode": "PAUSE",
	"default_filament_profile": [
		"Elegoo Generic PLA @0.6 nozzle"
	],
	"machine_start_gcode": ";ELEGOO NEPTUNE 4\nM220 S100 ;Set the feed speed to 100%\nM221 S100 ;Set the flow rate to 100%\nM104 S140\nM190 S[bed_temperature_initial_layer_single]\nG90\nG28 ;home\nG1 Z10 F300\nG1 X67.5 Y0 F6000\nG1 Z0 F300\nM109 S[nozzle_temperature_initial_layer]\nG92 E0 ;Reset Extruder\nG1 X67.5 Y0 Z0.4 F300 ;Move to start position\nG1 X167.5 E30 F400 ;Draw the first line\nG1 Z0.6 F120.0 ;Move to side a little\nG1 X162.5 F3000\nG92 E0 ;Reset Extruder\n",
	"machine_end_gcode": ";PRINT_END\nG91 ;Relative positionning\nG1 E-2 F2700 ;Retract a bit\nG1 E-8 X5 Y5 Z3 F3000 ;Retract\nG90 ;Absolute positionning\nG1 X10 Y220 F6000;Finish print\nM106 S0 ;Turn-off fan\nM104 S0 ;Turn-off hotend\nM140 S0 ;Turn-off bed\nM84 X Y E ;Disable all steppers but Z",
	"before_layer_change_gcode": ";BEFORE_LAYER_CHANGE\nG92 E0\n;[layer_z]\n\n",
	"layer_change_gcode": ";AFTER_LAYER_CHANGE\n;[layer_z]",
	"scan_first_layer": "0"
}